DIP 100 (C)

DYNAMIC ISOPHONE PROCESSOR

HOW TO INSTALL:

Connect the DIP100(C) as follow

Disconnect the speakers from your amplifier and connect them to the output of the DIP100(C). Then connect the output of your

existing amplifier to the input of the DIP1 OO(C).

Turn the trimmer (4) fully counterclockwise. Turn the volumecontrol of the amplifier to centre-position. Switch oft tone­ control or put the controls in mid­ position. Switch oft loudness.

Switch on your existing equipment. Leave the DIP1 OO(C) switched oft. Play your favorite compact disc and try to keep in mind, how loud the music sounds at that moment.

Then switch on the DIP1 OO(C). Soundlevel will become low. Turn the trimmer (4) clockwise to adjust loudness to the same level as you remember. And preparation is done.

Slowly turn down the volume of your amplifier. Notice that the transparency of the music does not fade away at low listening levels any more.

And enjoy the satisfaction of isophonic amplification.

Manual

Write a review